1950 Mercury Coupe Custom
our shop |
restorations |
street rods |
custom work |
resto-mod |
before & after |
the fun page |
home |
Working on the drivers side, the front floor panel is in place, the braces below have been replaced, seat mount is welded on and the inner rocker fabricated and installed. Not much sheet metal is reporduced commercially for this car. If a quality part is produced, we often use that rather than fabricating in house. Outer rockers were purchased for the Merc Coupe however the quality was so poor we fabricated those as well. We have sheet metal equipment that includes a plenishing hammer, brake, shrinker / stretcher, bead roller, small wheel, mill, assorted welders, leading tools and much more.